Fellowship Hall Signal Map

Document Control

• Owner:
• Last Reviewed: 2026-09-20
• Audience: Leaders, trainers, and advanced operators
• Related Volunteer Role Guides: Fellowship Hall AV Operator
• Supporting Photos / Screenshots:

What this map shows

The interactive map below covers the complete Fellowship Hall device graph: the extended laptop presentation path to the ATEM and two TVs, the Canon CR-N300 SDI camera path, X32/SD16 audio to columns, subs, and stream, SR516 and DMX lighting, Companion and campus network control, LivestreamRelay delivery to YouTube and Facebook, and conditioner versus always-on power.

Switch between the Video / Livestream, Audio, Lighting, Network, and Power tabs, and arrange by Signal flow or Location. Select any device to read its role, where it lives, its connections and transport badges, and the failures documented against it.

Interactive map

The interactive map renders below. If JavaScript is unavailable, the plain-text signal flow in the next section describes the same paths.

Signal flow (text)

Video / Livestream:
  Canon CR-N300 (one static shot) ── SDI ── Blackmagic SDI-to-HDMI micro converter
      ── HDMI input 1 ── ATEM Mini Pro ── program HDMI ── monitor inside desk lid
  Windows laptop (extended desktop) ── HDMI ── splitter 1 ── HDMI input 2 ── ATEM
                                      └─ HDMI ── splitter 2 ── left TV + right TV
  ATEM ── RTMP ── LivestreamRelay (Azure) ── YouTube + Facebook
  ATEM ── USB-C ── flash drive (manual offload to campus shared storage)

Audio:
  XSW handheld / lapel ── SD16 inputs 1/2 ─┐
  Laptop 1/8-inch TRS ── dual 1/4-inch ── SD16 inputs 3/4
                                           ├─ AES50 both directions ── X32 Compact
  X32 Matrix 1/2 ── SD16 outs 1/2 ── Crown XTi 1002 ch 1/2 ── left/right ULD columns
  X32 Bus 1 ── SD16 out 3 ── two daisy-chained B1200D-PRO powered subs
  X32 Matrix 3/4 ── SD16 outs 5/6 ── ATEM stream audio
  SD16 channels 5–16: not yet defined

Lighting:
  UniFi switch ⇄ ArtNet-to-DMX converter ── DMX ── SR516
      ── DMX ── 6 EVE E-50Z + 8 SlimPAR Pro Q USB
  Companion LuminetDMX override ── network control for looks beyond SR516 presets

Network:
  Main campus network ── UniFi USW-Pro-Max-16-PoE
      ├─ power + control ── Canon CR-N300
      ├─ ethernet ── ArtNet-to-DMX converter
      ├─ ethernet ── Windows laptop
      ├─ ethernet ── X32 Compact
      ├─ network ── ATEM ── LivestreamRelay ── YouTube + Facebook
      └─ Companion phone/tablet emulator (QR, surface Fellowship Hall, page 12)
  Stream Scheduler service ── page-12 chapel scheduling action

Power:
  Rack conditioner ── X32, SD16, two subs, Crown amp, ATEM, XSW receiver, ATEM monitor
  Always-on power (not conditioner) ── laptop, SR516 + ArtNet converter, UniFi switch

Troubleshooting at a glance

• No camera — check the UniFi camera link, SDI, converter, and ATEM input 1.
• No laptop picture — confirm Extended display and check both HDMI splitter paths and TV inputs.
• No room audio — check conditioner, AES50, X32 meters, Matrix 1/2, Crown, and SD16 outputs 1/2.
• No stream audio — check Matrix 3/4 and SD16 outputs 5/6 into the ATEM.
• No stream — verify the page-12 New Chapel Stream / HCS Chapel scheduling action, ATEM stream, network, LivestreamRelay, YouTube, and Facebook.
• Lights dark — use an SR516 preset first, then check ArtNet ethernet, DMX, and fixture power.
• Power confusion — conditioner gear is turned on at setup and off at close; laptop, lighting, and switch remain on.